SNAX/HLS Configuration and Control Manual

Step 3. Planning Session BINDs
Planning the SNAX/HLS Environment
104705 Tandem Computers Incorporated 2–11
Alternate Code Set Allowed
This field determines whether the alternate code selection bit in the RH is examined.
Set this field to 0. SNAX/HLS verbs do not allow the setting of the code select bit in
the RH. This attribute is not interpreted by SNAX/HLS.
In the BIND message, this attribute is indicated in byte 6, bit 4. In HLSRDT, this
attribute is specified by the BIND attribute ALT-CODE-USE, where: NO corresponds
to 0 in the BIND message and YES corresponds to 1 in the BIND message.
Sequence Number Availability
This field determines the availability of sequence numbers for sync point
resynchronization. Be sure that the device can support sequence verification and/or
that the IBM product description is consistent with this bit. For example, under IMS,
be sure that the PTERM description allows sequence-number verification. Note that
this feature is available for TS Profile 4 only. This attribute is not interpreted by
SNAX/HLS.
In the BIND message, this attribute is indicated in byte 6, bit 5. In HLSRDT, this
attribute is specified by the BIND attribute SEQNO-USE, where: NO corresponds to 0
in the BIND message and YES corresponds to 1 in the BIND message.
BIS Sent
This field is not interpreted by SNAX/HLS.
In the BIND message, this attribute is indicated in byte 6, bit 6. In HLSRDT, this
attribute is specified by the BIND attribute BIS-SENT, where: NO corresponds to 0 in
the BIND message and YES corresponds to 1 in the BIND message.
Bind Response Queue Capability
This attribute is not interpreted by SNAX/HLS.
In the BIND message, this attribute is indicated in byte 6, bit 7. In HLSRDT, this
attribute is specified by the BIND attribute BIND-QUEUING, where: NO corresponds
to 0 in the BIND message and YES corresponds to 1 in the BIND message.