SNAX/HLS Management Programming Manual

Event Message Descriptions
Event Management
104708 Tandem Computers Incorporated 8–5
Unconditional Tokens
ZSPI–TKN–SSID
is the subsystem ID for SNAX/HLS, as described in the Distributed Systems
Management (DSM) Programming Manual.
ZEMS–TKN–EVENTNUMBER
is the event number. Its value is ZHLS–EVT–BAD–RDT–DEV.
ZEMS–TKN–SUBJECT–MARK
serves to mark the token that follows it in the event message buffer as the subject
of the event message. In this message, the subject token is
ZCOM–TKN–SUBJ–PROC.
ZCOM–TKN–SUBJ–PROC
is the name of the SNAX/HLS process, as described in Section 6, “Common
Definitions.” The value of this token corresponds to the value <1> in the text
message.
ZSPI–TKN–MANAGER
is the name of the SNAX/HLS process.
ZEMS–TKN–EMPHASIS
contains the value ZSPI–VAL–FALSE, indicating that this is not considered a
critical event.
ZEMS–TKN–CONSOLE–PRINT
contains the value ZSPI–VAL–TRUE. This token is described in the Event
Management Service (EMS) Manual.
(ZEMS–TKN–) CPU, CRTPID, GENTIME, LOGTIME, PIN, SYSTEM, and USERID
are standard EMS tokens described in the Event Management Service (EMS) Manual.
ZCMK–TKN–XFNAME
contains the name of the file that SNAX/HLS attempted to load. This value
corresponds to the value <2> in the text message.
Cause. An attempt was made to load a RDT file from a device other than disk.
Effect . The attempt to load the file is abandoned. If the load is the result of program
initiation, the SNAX/HLS program is aborted.
Recovery. Use a disk file.