SNAX/XF and SNAX/APN Configuration and Management Manual

SNAX/APN Dependent LU Support (XLF and ELF)
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
7-2
Configuring for PLU Acquire

Configuring for PLU Accept Using ELF
Configuring for PLU Acquire
You should have performed Tasks 1 through 3 of Configuration Quick Start on
page 1-1
.
Figure 7-1 on page 7-3 shows an example of a SNAX/APN configuration in which PLU
applications on a NonStop system can initiate sessions with remote SLUs (SNA
devices) in the adjacent SNA subarea network (but not vice versa). The SNAX/APN
SCF configuration alters the subsystem to allow SNAX/APN operation and adds the
LINE, remote PU, and remote LU objects. This example applies to SNAX/APN LEN
Node and End Node.
Notes.
1. A SNAX/APN line is configured as primary and nonswitched by default. For SNAX/APN,
point-to-point lines also can be configured with STATION NEGOTIABLE.
2. On SNAX/APN lines, the PU and LU objects are distinguished into local and remote.
3. For details of the SCF attributes for SNAX/APN, see the SCF Reference Manual for
SNAX/XF and SNAX/APN.