SNAX/XF and SNAX/APN Configuration and Management Manual

SNAX/APN Dependent LU Support (XLF and ELF)
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
7-7
Configuring for PLU Accept Using XLF
Figure 7-3 shows an example of SNAX/APN XLF PLU accept using SNAX Creator-2 to
start the CRT and ITI applications. This example applies to SNAX/APN LEN Node and
End Node.
Figure 7-3. SNAX/APN XLF PLU Accept with SNAX Creator-2
ILOGMGR
SNA Host
SNA Subarea
Network
LU
NonStop System
$SSCP
$SNAX1
Line ($SNAX1)
LU
SNA Communication
Controller
NCP
VTAM
PU
LU
SWAN Concentrator
ILOGMGR
Control File
VTAM List
SNAX
Creator-2
Process
SNAX/APN
Line
Handler
$CREA
#ILOG
#RPU1
#TLOG
SNAX/APN SCF Configuration
ADD LINE $SNAX1, MAXLOCALLUS 1
ADD LU $SNAX1.#TLOG, TYPE (14,21)
, SNANAME TDM1, PROTOCOL LOGON
, CREATOR #CREATE, DLUNAME #ILOG
ADD PU $SNAX1.#RPU1, TYPE(13,21)
, RECSIZE 265, MAXLUS 3, ADDRESS %HC0
ADD LU $SNAX1.#ILOG, PUNAME #RPU1
, TYPE (14,21), SNANAME IBM1
ADD APPL $SSCP.#CREATE
, APPLTYPE LUNSCRE, PASSWORD abcdef
START LINE $SNAX1, SUB ALL
ILOGMGR Control File
ILOGMGR=IBM1
TLOGMGR=TDM1
TDMAPPLS=(APL1,APL2,APL3)
SNAX Creator-2 SCF Configuration
ADD SU $CREA.\NODE.$SSCP.#CREATE
, PASSWORD abcdef
ADD APPL $CREA.C-APL1, METHOD PATHWAY
, PATHMON $PMON1, PROGRAM LEDGE
ADD APPL $CREA.C-APL2, METHOD PATHWAY
, PATHMON $PMON2, PROGRAM PAY
ADD APPL $CREA.C-APL3
, METHOD TACL
VTAM List
MYAPPLS VBUILD TYPE=APPL
IBM1 APPL ACBNAME=IBM1,AUTH=(ACQ,PASS)
APL1 APPL ACBNAME=APL1
APL2 APPL ACBNAME=APL2
APL3 APPL ACBNAME=APL3
LU
SNA peripheral Node
VST703.vsd