SNAX/XF and SNAX/APN Configuration and Management Manual

SNAX/APN Dependent LU Support (XLF and ELF)
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
7-12
Template LUs
You should have performed Tasks 1 through 3 of Configuration Quick Start on
page 1-1.
The two examples that follow show a SNAX/APN End Node using ELF PLU accept
and SNAX Creator-2 to start the ITI application, TACL. The examples do not apply to
SNAX/APN LEN Node because LEN Node does not support ELF. Figure 7-5 on
page 7-12 shows a single template LU defined under the network node server PU. In
this configuration, all subsequent sessions are established under the network node
server PU.
.
Figure 7-5. SNAX/APN ELF PLU Accept with SNAX Creator-2 (Example 1)
SNA Host
SNA Subarea
Network
LU
NonStop System
$SSCP
$SNAX1
Line ($SNAX1)
SNA Communication
Controller
NCP
SWAN Concentrator
SNAX
Creator-2
Process
SNAX/APN
Line
Handler
$CREA
VTAM
PU
#RPU1
SNAX Creator-2 SCF Configuration
ADD SU $CREA.\NODE.$SSCP.#CREATE
, PASSWORD abcdef
ADD APPL $CREA.C-MYTACL
, METHOD TACL
SNAX/APN End Node SCF
Configuration
ADD LINE $SNAX1
, MAXLLOCALLUS 1
ADD PU $SNAX1.#RPU1
, TYPE(13,21)
, RECSIZE 265
, MAXLUS 3
, ADDRESS %HC1
, CPNAME M13
, NNSERVER MAIN
Add a template LU for TACL
ADD LU $SNAX1.#MYITI
, PUNAME #RPU1
, TYPE (14,2)
, SNANAME ITIDUMMY
, PROTOCOL ITI
, LOCALSNANAME MYTACL
, DEVTYPE “3872-2”
, RECSIZE 1024
, CHARACTERSET EBCDIC
, CREATOR #CREATE
ADD APPL $SSCP.#CREATE
, APPLTYPE LUNSCRE
, PASSWORD abcdef
START LINE $SNAX1, SUB ALL
LU
SNA peripheral Node
VST705.vsd