APN Configuration and Management Manual

ManualsBrandsHP ManualsServerHP NonStop G-Series

151

152

153

154

155

156

157

158

159

160

Configuring for Ethernet Support

SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006

10-8

SAPs and Link-station Addresses

In Ethernet architecture (and other 802 access methods), service access points (SAPs)

are the interfaces between the LLC layer and the user application in the upper layers,

as shown in Figure 10-6 on page 10-9. Each SAP provides services related to the type

of protocol stack it supports, identifying the client layer to the lower layers and

indicating the format of the data passed between the layers.

Each SAP is identified by a hexadecimal SAP value. The SAP value typically identifies

to the receiving station what format the data portion of the frame is in. For example,

SAP value %H04 is considered an SNA Path Control individual SAP. This means that

the data is an SNA path information unit (PIU). Other SAP values have other

meanings; see Table 10-1 for sample values.

The important point to note from the table is that the SAP values indicating that the

data is an SNA PIU are always multiples of four. You may choose to use any of these

permissible values (X’04’, X’08’, X’0C’, and so on) when you use the SCF SAPINFO

attribute to configure SNAX/XF and SNAX/APN.

Each device attached to the LAN can have one or more SAPs, with each SAP

supporting a different protocol stack. For example, in Figure 10-6 on page 10-9 you

can see SAP 1 and SAP 2, both associated with a single device on the LAN, and each

supporting different protocols. Each SAP may support multiple applications all using

the same protocol; for example, protocol stack #2 demonstrates the support of three

separate link-station addresses.

The term link-station address describes the unique combination of SAP (with

associated data link services) and the MAC address of the device. The link-station

address is the functional equivalent of a PU address in SNA terminology. There is one

link-station at each end of a connection on the LAN, just as there is one PU at each

end of a traditional SDLC line.

Table 10-1. Architected LLC Service Access Points

HEX Definition Description

X’04’,

X’08’,

X’0C’ and so on.

SNA path control SAPs Used by SNA workstations and supported by

SNAX/XF and SNAX/APN.

X’05’ Path control group SAP A broadcast address to all SNA SAPs. (Not

supported by SNAX/XF or SNAX/APN.)