SNAX/XF and SNAX/APN Configuration and Management Manual

Introduction to SCF for SNAX/XF and SNAX/APN
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
11-5
SCF Interface to SNAX/XF and SNAX/APN
Persistent changes to a SNAX subsystem must be sent through the WAN subsystem.
The WAN subsystem stores the changes, additions or deletions in the configuration
data base, and thus the modified configuration is available any time the SNAX
subsystem is restarted. An SCF command with persistent effect is shown in
Figure 11-3. (The command will not be executed until the SNAX subsystem is
restarted.)
Figure 11-2. An SCF Command With Dynamic Effect
Figure 11-3. An SCF Command With Persistent Effect
Terminal
SNAX
Subsystem
Line Handler
Process
1. ADD LINE $SNAP1
VST1102.vsd
WAN
Subsystem
$ZZWAN
1. ADD DEVICE $ZZWAN.#SNAXP1
2. Create
object
DEVICE
Object
($ZZWAN.#SNAP1)
Terminal
VST1103.vsd