APN Configuration and Management Manual

SCF Commands for SNAX/XF and SNAX/APN

SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006

13-2

Command Descriptions

The remainder of this section describes the SCF commands that operate on SNAX/XF

and SNAX/APN subsystem objects. It defines the function of each command, gives the

command syntax, provides any special considerations, and gives examples. The

command descriptions are given in alphabetic order.

The commands described in this manual are a subset of the commands available

through SCF. For information about other SCF commands, including those used for

general SCF operation (such as the ASSUME command), see the SCF Reference

Manual for G-series RVUs.

Note. The syntax in this section shows that the object type and object name are required for

all commands, except those that accept the null object type. However, you can omit the

object type, the object name, or both if you have previously set defaults for them in an

ASSUME command.