SNAX/XF and SNAX/APN Configuration and Management Manual

SCF Commands for SNAX/XF and SNAX/APN
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
13-5
ABORT Command

If the TLOGMGR LU has an active session with the ILOGMGR LU on the IBM
system when an ABORT LU command is issued to the TLOGMGR LU:

The session between the TLOGMGR LU and the ILOGMGR LU terminates.

The TLOGMGR LU is put in the STOPPED state.
Any queued session requests from the ILOGMGR LU that are pending are
terminated. However, any existing sessions to the remote LUs that represent the
terminals are not affected.

When the LU object name specified in the ABORT LU command is the subdevice
name specified on the NonStop system, only the LU represented by the subdevice
name specified on the NonStop system is aborted.

If the subdevice name specified on the NonStop system is that of an automatically
created remote LU, the session to the terminal is terminated, thus causing this LU
to be deleted automatically.
Examples for SNAX/XF
->ABORT LINE $SNAP2
->ABORT LINE $SNAP3,SUB LU
->ABORT LINE $SNAP4,SUB ALL
->ABORT LINE ($SNAP6,$SNAP7),SUB PU
->ABORT LU $SNAP1.#LU1
->ABORT PU $SNAP1.#PU1
->ABORT PU $SNAS1.#PU3,SUB ONLY
->ABORT SUBSYS $SSCP,SUB ONLY
->ABORT SESSION $SNAP1.#LU1
Examples for SNAX/APN
->ABORT APPL $SSCP.#CREA2
->ABORT LINE $APN2
->ABORT LINE $APN3,SUB LU
->ABORT LINE $APN4,SUB ALL
->ABORT LINE ($APN6,$APN7),SUB PU
->ABORT LU $APN1.#LU1
->ABORT PU $APN1.#PU1
->ABORT PU $APN1.#PU3,SUB ONLY
->ABORT SUBSYS $SSCP,SUB ONLY
->ABORT SESSION $APN1.#LU1.D95F195317EA70FE