SNAX/XF and SNAX/APN Configuration and Management Manual

SCF Commands for SNAX/XF and SNAX/APN
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
13-14
ADD LU Command
ADD LU Command
The ADD LU command configures an LU object within the SNAX/XF and SNAX/APN
subsystems. It is a sensitive command.
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file. file-spec must be a partially or fully qualified file name. If this option is not
specified, the output is sent to the home terminal.
ADD [ / OUT file-spec / ] LU object-name
[, LIKE object-name ] [, attribute-spec ]...
attribute-spec is described for each case in the following pages.
(items not in square brackets are required):
ADDRESS integer
PROTOCOL { CRT | ITI | PRT |SNALU }
PUNAME #pu-name
TYPE ( 14, integer )
[ ACTLU { COLD | WARM } ]
[ ALLOWEDMIX integer ]
[ ASSOCIATE lu-name ]
[ AUTOLOGON "ess-table-entry-name" ]
[ BINDENTRY "bind-table-entry-name" ]
[ BINDTABLE bind-table-name ]
[ CDI { NORMAL | ENHANCED | SPECIAL } ]
[ CHARACTERSET { ASCII | EBCDIC | KATAKANA } ]
[ DBCS IBMKANJI
IBMMIXED
JEFKANJI
NONE ]
[ DEVTYPE { "IBM-devtype-IBM-model" }
{ IBM-devtype [ -IBM-model ] }
{ "6530-1" }
{ 6530-1 }
{ "6530-2" }
{ "6530-2 } ]
[ ERMODE { OFF | OLDAPPL | NEWAPPL } ]
[ ESSTABLE ess-table-name ]
[ LUDISABLED { ON | OFF} ]
[ NUMBEROFLUS integer ]
[ NOACQ { ON | OFF } ]
[ PASSTHRU { ON | OFF } ]
[ RECSIZE integer ]
[ REGISTER { NO | YES | CDS } ]
[ SCREENSIZE { DEFAULT | ALTERNATE } ]
[ STATIC { ON | OFF } ]
[ SENDUNBIND01 { YES | NO } ]