SNAX/XF and SNAX/APN Configuration and Management Manual

SCF Commands for SNAX/XF and SNAX/APN
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
13-21
ADD PU Command
LIKE object-name
identifies an existing PU object whose attribute values serve as a model for the
values of the attributes of the object being created. object-name must specify an
existing object of the same type.
attribute-spec
is a specification of an attribute and a value to be assigned to it. If the LIKE syntax
is used, attribute-spec overrides the setting derived from the LIKE object for
that attribute.
All ADD PU attributes and their values are described in Section 14, Attributes for
SNAX/XF and SNAX/APN.
Example for SNAX/XF
->ADD PU $SNAP1.#PU1,ADDRESS 1,TYPE (13,1),RECSIZE 256, &
->MAXLUS 15
Example for SNAX/APN
->ADD PU $APN1.#PU1, ADDRESS %HC1, MAXLUS 10, RECSIZE 521, &
->TYPE (13, 21), DYNAMIC ON