SNAX/XF and SNAX/APN Configuration and Management Manual

SCF Commands for SNAX/XF and SNAX/APN
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
13-22
AGGREGATE Command
AGGREGATE Command
The AGGREGATE command retrieves counts of active and defined objects
subordinate to the specified object. It is a nonsensitive command.
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file. file-spec must be a partially or fully qualified file name. If this option is not
specified, the output is sent to the home terminal.
object-name
is the name of the object whose subordinate objects are to be counted.
Considerations

The specified object is not included in the counts; only its subordinate objects are
counted.

If the object type is SUBSYS, then a count of switched floating PUs and LUs is
accumulated along with the counts for PUs and LUs that are subordinate to lines.

If the SNAX/XF object type is LINE or PU, switched floating PUs and LUs are not
counted.

If the SNAX/APN object type is LINE, the following SNAX/APN objects are
counted: local LUs, remote LUs, remote PUs, and the local PU #ZNT21.

If the object type is PU and object-name is #ZNT21, a count of all subordinate
local LUs is accumulated.

If the object type is PU and object-name is the name of a remote PU, a count of
all subordinate remote LUs is accumulated.

Aggregate counts are returned for LINE, PU, and LU objects only.
Examples
The following examples illustrate the AGGREGATE command as applied to the LINE,
PU, and SUBSYS objects.
AGGREGATE [ / OUT file-spec / ] { LINE }
{ PU }
{ SUBSYS }
{ object-name }
{ ( object-name [, object-name ]... ) }