SNAX/XF and SNAX/APN Configuration and Management Manual
SCF Commands for SNAX/XF and SNAX/APN
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
13-35
ALTER LU Command
Examples for SNAX/APN
->ALTER LU $APN1.#LL1, SNANAME AL37C101
->ALTER LU $APN1.#crt,PROTOCOL CRT, SENDUNBIND01 YES
All ALTER LU attributes and their values are described in Section 14, Attributes for
SNAX/XF and SNAX/APN.
Considerations For SNAX/APN
Local LU Object—APPC
When APPC is used, the attribute-spec for the local LU object type in the ALTER
command is one of the following attribute name and value combinations:
Remote LU Object—APPC
When APPC is used, the attribute-spec for the remote LU object type in the
ALTER command is one of the following attribute name and value combinations:
Local LU Object—XLF TLOGMGR LU
attribute-spec for the TLOGMGR local LU object type in the ALTER command is
one of the following attribute name and value combinations:
[ PROTOCOL SNALUXS ]
[ REGISTER { YES | NO | CDS } ]
[ SNANAME snaname ]
[ TPF { LOW | MED | HI } ]
[ SNANAME snaname ]
[ SNANETID snanetid ]
[ TPF { LOW | MED | HI } ]
[ APPLFILE $volume.subvol.filename ]
[ CDI { ENHANCED | NORMAL | SPECIAL } ]
[ CHARACTERSET { ASCII | EBCDIC | KATAKANA } ]
[ CREATOR #subdevice-name ]
[ DLUNAME { #dluname | ( #dluname |, #dluname1 |, #dluname2 ]
[ |, #dluname3 ) } ]
[ MAXREADCNT integer ]
[ PROTOCOL LOGON ]
[ RSPTYPE { DR | ER } ]
[ RSPTYPEWR {WRER | WRDR } ]
[ SCREEN { NOSCROLL | SCROLL } ]
[ SCREENSIZE { DEFAULT | ALTERNATE } ]
[ SNANAME snaname ]
[ TPF { LOW | MED | HI } ]