SNAX/XF and SNAX/APN Configuration and Management Manual

SCF Commands for SNAX/XF and SNAX/APN
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
13-37
ALTER PU Command
ALTER PU Command
The ALTER PU command changes or removes the values of attributes that define
characteristics of a PU object. An ALTER PU command can be performed only when
the LINE object is in the STOPPED state. ALTER is a sensitive command.
OUT file-spec
causes any SCF output generated for this command to be directed to the specified
file. file-spec must be a partially or fully qualified file name. If this option is not
specified, the output is sent to the home terminal.
object-name
is the name of the PU object whose attribute values are to be changed or removed.
ALTER [ / OUT file-spec / ] PU object-name
[, LIKE object-name ] [, attribute-spec ]...
attribute-spec is one of the following:
[ ACTPU { COLD | WARM } ]
[ ADDRESS integer ]
[ ASSOCIATESUBDEV device-name ]
[ AUTOLOGON "ess-table-entry-name" ]
[ BINDENTRY "bind-table-entry-name" ]
[ BINDTABLE bind-table-name ]
[ CALLADDR string ]
[ CALLVALIDATE [ BOTH | CALLADDR | CONNID | NONE ] ]
[ CONNID "string" ]
[ CPNAME cpname ]
[ DYNAMIC ON | OFF ]
[ ESSTABLE ess-table-name ]
[ L3RETRY integer ]
[ L3TIMEOUT time ]
[ MAXLUS integer ]
[ MAXPTS integer ]
[ NNSERVER { NONE | MAIN | BKUP | OTHER } ]
[ NOACQ { ON | OFF } ]
[ PUIDBLK integer ]
[ PUIDNUM integer ]
[ RECSIZE integer ]
[ REQDISCONTTYPE { IMMEDIATE | NORMAL } ]
[ REQMS { ON | OFF } ]
[ SERVICECOUNT integer ]
[ TG ]
[ TYPE ( 13, { 1 | 2 } ) ]
[ WINDOW integer ]