SNAX/XF and SNAX/APN Configuration and Management Manual

SCF Commands for SNAX/XF and SNAX/APN
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
13-49
INFO Command
ApplType
is always 6-LUNSCRE in a SNAX/APN environment, as described in Section 14,
Attributes for SNAX/XF and SNAX/APN.
Creator
does not apply in a SNAX/APN environment.
INFO LINE Example
The following example illustrates an INFO LINE command without the DETAIL option,
and its returned display.
Command Example:
->INFO LINE $SNAP1
Returned Display:
Display Descriptions:
Line
lists the name of the line being reported.
All other INFO LINE display fields are described in Section 14, Attributes for SNAX/XF
and SNAX/APN.
Considerations When Using Multiple Service-Manager Processes
When the SCF SETMANAGER command is issued, all subsequent SCF commands
are directed to the service manager named. If a SETMANAGER command is not
issued, the default $SSCP is used. Issuing a SETMANAGER command without
identifying a specific service-manager process resets the service-manager process to
the default.
In the following example, an INFO LINE, SERVICEMANAGER or INFO LINE, DETAIL
command is issued when a line has not been added to any service manager:
INFO LINE $SNA1,SERVICEMANAGER
The INFO LINE command completes successfully and displays the following message:
ServiceManager ... UNKNOWN
SNAX Info LINE:
Line *Station *Switched *Duplex *Retries *Timeout
\SYS2.$SNAP1 PRIMARY OFF HALF 3 00:00:05.000