APN Configuration and Management Manual

SCF Commands for SNAX/XF and SNAX/APN

SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006

13-94

STATUS Command

The STATUS command displays information about the current status of an object. It is

a nonsensitive command.

OUT file-spec

causes any SCF output generated for this command to be directed to the specified

file. file-spec must be a partially or fully qualified file name. If this option is not

specified, the output is sent to the home terminal.

object-name

is the name of the object for which status information is to be displayed.

DETAIL

causes detailed status information to be displayed. If DETAIL is omitted, only one

line of information is displayed for each object.

The DETAIL option is not valid for APPL objects.

SUB [ subtype ]

selects the subordinate objects the command affects. subtype can be a

subordinate object type or one of the keywords ONLY, ALL, or NONE.

If a subordinate object type is named, only objects of that type are affected. ONLY

specifies that only the subordinate objects are affected. ALL specifies that the

named object and the subordinate objects are affected. NONE specifies that the

named object is affected but none of the subordinate objects are affected. If

subtype is omitted, ALL is assumed.

The SUB option is not valid for APPL or LU objects.

STATUS [ / OUT file-spec / ] { APPL }

{ LINE }

{ LU }

{ PU }

{ SUBSYS }

{ object-name }

{ ( object-name [, object-name ]... ) }

[, DETAIL ]

[, SUB [ subtype ] ] [, SEL [ NOT ] state ]

[, info-item-name ]...