SNAX/XF and SNAX/APN Configuration and Management Manual

SCF Commands for SNAX/XF and SNAX/APN
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
13-97
STATUS Command
Command Example:
->STATUS APPL #APPL1
Returned Display:
Display Descriptions:
Name
is the name of the APPL object being reported on.
State
indicates the current state of the named object. For a description of the valid states
for APPL objects, see Section 12, Objects for SNAX/XF and SNAX/APN.
STATUS LINE Example
The following example illustrates the STATUS LINE command without the DETAIL
option, and its returned display.
Command Example:
->STATUS LINE $SNA1
Returned Display:
Display Descriptions:
Name
indicates the name of the LINE object being reported.
State
indicates the current state of the LINE object. For a description of the valid object
states for LINE objects, see Section 12, Objects for SNAX/XF and SNAX/APN.
Inuse
indicates whether this line is presently in passthrough mode. An ON indicates that
either this line is in passthrough mode or that this line has at least one subordinate
LU open.
SNAX Status APPL
Name State
\SYS2.$SSCP.#APPL1 STARTED
SNAX Status LINE
Name State Inuse LineState
\SYS1.$SOXP8 STOPPED OFF INACTIV