SNAX/XF and SNAX/APN Configuration and Management Manual

SCF Commands for SNAX/XF and SNAX/APN
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
13-100
STATUS Command
ACTLRSPPD
indicates that the line is waiting for a response to an SNA ACTLINK request
ALKRSPPD
indicates that the line is waiting for a response to an SNA ADDLINK request.
DACTLRSPPD
indicates that the line is waiting for a response to an SNA DACTLINK request.
DIAGACTIVE
indicates that the line is in diagnostics mode, that is, diagnostic functions are
currently active.
INACTIVE
indicates that the line has been added but is in a quiesced state.
MLKRSPPD
indicates that the line is waiting for a response to an SNA MODLINK request.
NOTADDED
indicates that the line has not yet been added with the ADD command.
Path
indicates the primary path to the CLIP.
I/O Addr
is the address of the ATP6100 line in the form (PATYPE, CHANNEL,
CLIPNUMBER, LINENUMBER). A value of 4 for PATYPE indicates that the line is
an IP node. CHANNEL is no longer used and is always 0. LINENUMBER and
CLIPNUMBER identify the line on the ServerNet WAN Concentrator. This attribute
is not applicable to X.25 lines (type 58,3).
Track ID
indicates the unique identification of the concentrator (adapter). This attribute is not
applicable to X.25 lines (type 58,3).
Preferred IP
indicates the preferred IP address used by the process. This attribute is not
applicable to X.25 lines (type 58,3).