SNAX/XF and SNAX/APN Configuration and Management Manual

SCF Commands for SNAX/XF and SNAX/APN
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
13-103
STATUS Command
LineState
indicates internal state information about this line. For valid values, see STATUS
LINE Example on page 13-97.
STATUS LU Example
The following example illustrates the STATUS LU command without the DETAIL option,
and its returned display.
Command Example 1:
->STATUS LU $SNA1.#LU1
Command Example 2:
A wild-card character (*) can be used to display the status of all LUs subordinate to a
line.
->STATUS LU $SNA1.*
Returned Display for Command Example 1:
Display Descriptions:
Name
indicates the name of the line to which the corresponding LU is connected. This
value is not returned unless the specified switched LU is connected.
State
indicates the current state of the LU object. For a description of the valid object
states for LU objects, see Section 12, Objects for SNAX/XF and SNAX/APN
.
LUSessState
indicates the current state of the LU-LU session associated with this LU. The
following are valid values that may appear under the LUSessState heading:
ACT & SUSP
indicates that a non-passthrough (that is, an application on a NonStop system)
session is active, but that further opens have been stopped.
ACTIVE
indicates that a non-passthrough session is active and opens have not been
stopped.
SNAX Status LU
Name State LUSessState SDN SessionCount
\SYS1.$SNA1.#LU1 STARTED ACTIVE 2 5