SNAX/XF and SNAX/APN Configuration and Management Manual

SCF Commands for SNAX/XF and SNAX/APN
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
13-106
STATUS Command
ACTLURSPPD
indicates that the LU is waiting for a response to an SNA ACTLU request. Note
that this state only applies to LUs on primary lines.
CINITRSPPD
indicates that the LU is waiting for a response to an SNA CINIT request. Note
that this state only applies to LUs on primary lines.
CTERMRSPPD
indicates that the LU is waiting for a response to an SNA CTERM request.
Note that this state only applies to LUs on primary lines.
DACTLURQPD
indicates that the LU is waiting for an SNA DACTLU request. Note that this
state only applies to LUs on secondary lines.
DACTLURSPPD
indicates that the LU is waiting for a response to an SNA DACTLU request.
Note that this state only applies to LUs on primary lines.
INACTIVE
indicates that the specified LU has been added with the ADD command, but is
quiesced.
INITRSPPD
indicates that the LU is waiting for a response to an SNA INITSELF request.
OFFLINE
indicates that an LU connected to a SNAX/XF and SNAX/APN primary line
only is active but powered off.
TERMRSPPD
indicates that the LU is waiting for a response to an SNA TERMSELF request.
Opens
indicates whether or not opens are currently permitted to the specified line. The
following are valid values that may be returned under the Opens heading:
ALLOWED
indicates that applications can issue OPEN procedure calls for the LU.