SNAX/XF and SNAX/APN Configuration and Management Manual

SCF Commands for SNAX/XF and SNAX/APN
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
13-111
STATUS Command
Name
is the configured subdevice name of the LU and the name of the line to which it
is subordinate.
SNAName
is the SNA name of the LU.
SNANetid
is the SNA network identifier of the node in which this LU is located.
Detailed STATUS LU, SUB ONLY Example (Acquired Remote LU)
The following example illustrates the STATUS LU command with the DETAIL and SUB
ONLY options and shows its returned display for an acquired remote LU.
Command Example:
->STATUS LU $APN1.#ITI01, SUB ONLY, DETAIL
Returned Display:
Display Descriptions:
E79F2017 0C71650E
is the fully qualified procedure correlation identifier (FQPCID) identifying the
session for the LU.
TPF
indicates the transmission priority field (TPF) for the specified session. The
following values can appear under the TPF heading:
LOW
specifies that this session has low priority relative to other sessions.
MED
specifies that this session has medium priority relative to other sessions.
SNAX Detailed Status Session E79F2017 0C71650E
TPF............ HI
LU :
Name........... \SNADEV4.$APN1.#ITI01
SNAName........ L327004E SNANetid..... USPALO01
Primary........ PRI
PriTrace....... ACTIVE
LocalSNAName... TL17C103