SNAX/XF and SNAX/APN Configuration and Management Manual

SCF Commands for SNAX/XF and SNAX/APN
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
13-112
STATUS Command
HI
specifies that this session has high priority relative to other sessions.
LU
presents information about the LU object specified in the STATUS command.
Name
is the fully qualified name of the LU.
SNAName
is the SNA name of the LU.
SNANetid
is the SNA network identifier of the node in which this LU is located.
Primary
indicates whether the LU is primary or secondary in this session.
PriTrace
indicates the current state of trace activity for this LU (primary). Valid values
are ACTIVE and INACTIVE.
LocalSNAName
is the name configured in the LOCALSNANAME attribute (described in
Section 14, Attributes for SNAX/XF and SNAX/APN) for this acquired remote
LU.
STATUS PU Example
The following example illustrates the STATUS PU command without the DETAIL
option, and its returned display.
Command Example:
->STATUS PU $SNA1.#PU3
Returned Display:
Display Descriptions:
SNAX Status PU
Name State Test PUState
\SYS1.$SNA3.#PU3 STARTED INACTIVE ACTIVE