SNAX/XF and SNAX/APN Configuration and Management Manual

SCF Commands for SNAX/XF and SNAX/APN
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
13-114
STATUS Command
DISCRSPPD
indicates that the PU is waiting for a response to an SNA DISCONTACT
request. This state applies only to PUs on primary lines.
INACTIVE
indicates that the PU has been added but is in a quiesced state.
MLKSTARSPPD
indicates that the PU is waiting for a response to an SNA MODLINK STATION
request.
RQDISCRSPPD
indicates that the PU is waiting for an SNA REQUEST DISCONTACT. Note
that this state applies only to PUs on secondary lines.
Detailed STATUS PU Example
The following example illustrates the STATUS PU command with the DETAIL option,
and its returned display.
Command Example:
->STATUS PU $SNA3.#PU3, DETAIL
Returned Display:
Display Descriptions:
DesiredState
provides a mechanism to notify the service manager when an operator issues a
START, ABORT, or STOP command for a line, PU, or LU.
NONE
indicates that no commands have been issued for the PU.
ACTIVE
indicates that a START command has been issued for the PU.
SNAX Detailed Status PU \SYS2.$SNA1.#P0
PUState.......... INACTIVE State........... STOPPED
DesiredState..... INACTIVE(Abort) SwLine.......... N/A
SwState.......... N/A Test............ INACTIVE
PriTrace......... INACTIVE BkpTrace........ INACTIVE
AssociateSubDev.. $X251.#p1