SNAX/XF and SNAX/APN Configuration and Management Manual

SCF Commands for SNAX/XF and SNAX/APN
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
13-115
STATUS Command
INACTIVE (Abort)
indicates that an ABORT command has been issued for the PU.
INACTIVE (Stop)
indicates that a STOP command has been issued for the PU.
PUState
provides detailed internal state information pertaining to the specified PU. The
following are valid values that may appear under the PUState heading:
ACTIVE
indicates that the PU has been defined and initialized. Consequently, it can
transmit and receive end-user data.
ACTPURSPPD
indicates that the PU is waiting for a response to an SNA ACTPU request.
Note that this state only applies to PUs on primary lines.
ALKSTARSPPD
indicates that the PU is waiting for a response to an SNA ADDLINK STATION
request
CONTACTED
indicates that the PU has been contacted with the SNA CONTACT command.
CONTACTPD
indicates that the PU his waiting for an SNA CONTACT command.
DACTPURQPD
indicates that the PU is waiting for an SNA DACTPU request. Note that this
state applies only to PUs on secondary lines.
DACTPURSPPD
indicates that the PU has is waiting for a response to an SNA DACTPU
request. Note that this state applies only to PUs on primary lines.
DISCRSPPD
indicates that the PU is waiting for a response to an SNA DISCONTACT
request. This state applies only to PUs on primary lines.
INACTIVE
indicates that the PU has been added but is in a quiesced state.