SNAX/XF and SNAX/APN Configuration and Management Manual

SCF Commands for SNAX/XF and SNAX/APN
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
13-117
STATUS Command
BkpTrace
indicates the current state of trace activity for this PU (backup). Valid values are
ACTIVE and INACTIVE.
AssociateSubDev
indicates the name of the X25AM process and subdevice currently assigned to this
PU. This value is displayed only if (1) a SNAX/CM command is used with the
PORT parameter and this PU is active, or (2) the PU is configured with
ASSOCIATESUBDEV and has been started.
STATUS PU, SUB ALL Example
The following example shows the STATUS PU command with the SUB ALL option and
its returned display. Note that the PU object specified in the STATUS command is a
remote PU.
Command Example:
->STATUS PU $APN1.#RPU1, SUB ALL
Returned Display:
Display Descriptions:
Name
indicates the fully qualified name of the specified PU object.
State
indicates the current state for this object. For a description of the valid object
states, see Section 12, Objects for SNAX/XF and SNAX/APN.
SNAX Status PU
Name State Test PUState
\SYS1.$APN1.#RPU1 STARTED INACTIVE ACTIVE
SNAX Status LU
Name State LUSessState SDN SessionCount
\SYS1.$APN1.#RLU1...STARTED ACTIVE 0 5
SNAX Status Session
FQPCID LU Name PTNR-SNANAME Primary Trace
D95F1953 17EA70FE $SYS1.$APN1.#RLU1 TAPPL1 SEC INACTIVE
D95F1953 17EA70FF $SYS1.$APN1.#RLU1 TAPPL1 SEC INACTIVE
D95F1953 17EA7100 $SYS1.$APN1.#RLU1 TAPPL1 SEC INACTIVE
D95F1953 17EA7101 $SYS1.$APN1.#RLU1 TAPPL1 SEC INACTIVE
D95F1953 17EA7102 $SYS1.$APN1.#RLU1 TAPPL1 SEC INACTIVE
D95F1953 17EA70FE $SYS1.$APN1.#LLU1 AS4APP1 PRI INACTIVE
D95F1953 17EA70FF $SYS1.$APN1.#LLU1 AS4APP1 PRI INACTIVE
D95F1953 17EA7100 $SYS1.$APN1.#LLU1 AS4APP1 PRI INACTIVE
D95F1953 17EA7101 $SYS1.$APN1.#LLU1 AS4APP1 PRI INACTIVE
D95F1953 17EA7102 $SYS1.$APN1.#LLU1 AS4APP1 PRI INACTIVE