SNAX/XF and SNAX/APN Configuration and Management Manual

SCF Commands for SNAX/XF and SNAX/APN
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
13-118
STATUS Command
Test
indicates whether diagnostic testing of the specified PU object is currently in
progress. For valid values, see STATUS PU Example on page 13-112.
PUState
indicates detailed internal state information pertaining to this PU. For valid values,
see STATUS PU Example on page 13-112.
STATUS SESSION Example
The following example shows the STATUS SESSION command and its returned
display.
Command Example:
->STATUS SESSION $APN1.#T16APP1.E79F201700861167
Returned Display:
Display Descriptions:
FQPCID
is the fully qualified procedure correlation identifier (FQPCID) of the session.
LU Name
is the fully qualified name of a local LU or remote LU engaged in the session.
Primary
indicates whether the LU is primary or secondary in this session.
PTNR-SNANAME
is the SNA name of the LU engaged in the session with the LU specified in
LU Name.
Trace
indicates whether or not a trace is being performed.
Detailed STATUS SESSION Example (LU Used for APPC)
The following example shows the STATUS SESSION command with the DETAIL
option, and its returned display for an LU used for APPC.
SNAX Status Session
FQPCID LU Name Primary PTNR-SNANAME Trace
E79F2017 00861167 \SYS1.$APN1.#T16APP1 PRI AS4APPL1 INACTIVE