SNAX/XF and SNAX/APN Configuration and Management Manual

SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
14-1
14
Attributes for SNAX/XF and
SNAX/APN
Attributes are the named, configurable characteristics of the objects for a subsystem.
This section describes the attributes for the SNAX/XF and SNAX/APN subsystems,
which are specified as parameters to one or more of the SCF commands ADD,
ALTER, and INFO.
The attributes are listed in alphabetic order. For each attribute, the following
information is given:

The attribute name (the SCF keyword for the attribute) and whether the attribute
applies to SNAX/XF or SNAX/APN. If the attribute applies to both, then neither
subsystem is specifically named.

The default value, if any (the value used when the attribute is not specified in an
ADD command)

The set, or range, of values that are valid for the attribute

The object types to which the attribute can apply

The meaning of the attribute, including usage considerations
When these attributes appear in INFO displays, their names are displayed in initial
caps rather than in all uppercase letters. Attributes that can be configured using the
ADD or ALTER command for the indicated object type are labeled with an asterisk (*)
in the INFO displays.
ACTLU - for SNAX/XF Only
ACTLU specifies whether a cold start or a warm start should be performed when an
SNA ACTLU command is sent to the LU object on a primary line when the LU is
started.
Default: ACTPU value specified for the PU to which the LU is subordinate
Value: COLD | WARM
Objects: LU