APN Configuration and Management Manual

Attributes for SNAX/XF and SNAX/APN

SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006

14-25

FLAGFILL

FLAGFILL specifies whether or not the bit-synchronous controller is to transmit SDLC

flags (%h7E) when the line is idle.

FLAGFILL ON indicates that flags are to be sent; FLAGFILL OFF indicates that no

SDLC flags are to be sent.

INITSELFACTION

For SNAX/XF LUs with PROTOCOL SNALU, INITSELFACTION defines the action that

will be taken when an INIT-SELF is received from a SLU and the LU has not been

opened by an application.

The following values are valid for this attribute in an ADD or ALTER command:

An SCF INFO LU command will display INITSELFACTION N/A for all LUs that this

attribute does not support.

Default: OFF

Value: ON | OFF

Objects: LINE

Default: NEGRSP

Value: NEGRSP | POSRSP | SENDNSPE | HOLDCINIT

Objects: SNAX/XF LU (PROTOCOL SNALU only)

NEGRSP specifies that a negative response will be sent to the SLU.

POSRSP specifies that a positive response will be sent to the SLU. This value

should be specified only if SENDNSPE or HOLDCINIT don’t produce

the desired results and then only if the application is configured to

acquire a SLU following the LU open.

SENDNSPE specifies that a positive response will be sent to the SLU. The +rsp

will be followed by:



an NSPE request if the INIT-SELF is format 0



a NOTIFY request if the INIT-SELF is format 1

Note that SNAX/XF does not support the format 2 INIT-SELF.

HOLDCINIT specifies that a positive response will be sent to the SLU. When the

LU is opened by an application, a CINIT will be sent to the PLU.