SNAX/XF and SNAX/APN Configuration and Management Manual

Attributes for SNAX/XF and SNAX/APN
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
14-29
LINKSTATIONMODE
LINKSTATIONMODE
LINKSTATIONMODE specifies the level-2 protocol to be used on the line. The value
NRM specifies normal response mode.
When adding line type 58,5 (SDLC), you should either omit this attribute or specify the
value NRM. When adding line type 58,3 for X.25 lines, you should omit this attribute.
LNMAXIN
LNMAXIN replaces the retired Token-Ring attribute TPF - for SNAX/APN Only on
page 14-70. LNMAXIN is the maximum number of I-frames that can be received before
an acknowledgment must be sent. Regardless of which attribute name is specified on
an SCF ADD/ALTER command, the SCF INFO command displays LNMAXIN.
LNMAXOUT
LNMAXOUT replaces the retired Token-Ring attribute TRMAXOUT on page 14-70.
LNMAXOUT is the maximum number of I-frames that can be sent before an
acknowledgment must be received. LNMAXOUT performs the same function as the
WINDOW attribute does for non-LAN configurations. Regardless of which attribute
name is specified on an SCF ADD/ALTER command, the SCF INFO command
displays LNMAXOUT.
LNMAXOUTINCR
LNMAXOUTINCR replaces the retired Token-Ring attribute TRMAXOUTINCR on
page 14-70. LNMAXOUTINCR is the increment value for dynamic windowing (currently
not implemented for Ethernet). Regardless of which attribute name is specified on an
SCF ADD/ALTER command, the SCF INFO command displays LNMAXOUTINCR.
Default: NRM
Value: NRM
Objects: LINE
Default: 7
Value: 1 - 127
Objects: PU (Ethernet or Token-Ring only)
Default: 127
Value: 1 - 127
Objects: PU (Ethernet or Token-Ring only)
Default: 1
Value: 1 - 127
Objects: PU (Ethernet or Token-Ring only)