APN Configuration and Management Manual

Attributes for SNAX/XF and SNAX/APN

SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006

14-31

LNT1

LNT1 replaces the retired Token-Ring attribute TRT1 on page 14-71. LNT1 is the reply

timer used to detect the lack of a required response from a remote station. This

attribute is optional. Regardless of which attribute name is specified on an SCF

ADD/ALTER command, the SCF INFO command displays LNT1.

LNT2

LNT2 replaces the retired Token-Ring attribute TRT2 on page 14-71. LNT2 is the

receiver acknowledgment timer used to delay sending acknowledgments. When the

LNT2 timer expires, an acknowledgment to previously received frames is sent. The

value of LNT2 must be less than the value of LNT1; if not, an error message will be

generated for the SCF ADD or ALTER PU command. This attribute is optional.

Regardless of which attribute name is specified on an SCF ADD/ALTER command, the

SCF INFO command displays LNT2.

LNTI

LNTI replaces the retired Token-Ring attribute TRTI on page 14-71. LNTI is the

inactivity timer used to detect a link failure. This attribute is optional. Regardless of

which attribute name is specified on an SCF ADD/ALTER command, the SCF INFO

command displays LNTI.

LOCALSNANAME–SNAX/APN Only

The LOCALSNANAME attribute can contain from 1 through 8 characters and must use

the SNA 1134 character set. The configured LOCALSNANAME should not duplicate

the name of an LU on another node in the IBM network.

Default: 1 (second)

Value: 0 - 65535 (seconds)

Objects: PU (Ethernet or Token-Ring only)

Default: 0.1 (second)

Value: 0 - 65534 (seconds)

Objects: PU (Ethernet or Token-Ring only)

Default: 30 (seconds)

Value: 0 - 65535 (seconds)

Objects: PU (Ethernet or Token-Ring only)

Default: None

Value: String of 1 through 8 characters in the SNA type 1134 character set

Objects: LU