APN Configuration and Management Manual

ManualsBrandsHP ManualsServerHP NonStop G-Series

371

372

373

374

375

376

377

378

379

380

Attributes for SNAX/XF and SNAX/APN

SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006

14-34

MAXLOCALLUS - for SNAX/APN Only

MAXLOCALLUS specifies the maximum number of local LUs allowed on the line. The

value cannot exceed the value specified for MAXLUS. MAXLOCALLUS is a required

attribute and should always be specified with a nonzero value. If MAXLOCALLUS is

allowed to default, SNAX/APN cannot operate on the line.

MAXLOCALLUS impacts the value of MAXLUS for the LINE object. For details, see

the Note under MAXLUS.

MAXLUS

MAXLUS specifies the maximum number of LUs that can be subordinate to the given

line or PU. When MAXLUS is applied to a LINE object, the sum of MAXLUS on all PUs

for the given line cannot exceed this value. For SNAX/APN, see the Note below.

For LINE objects, the default value is 32. The valid range of values is 1 through 2048

for LINE objects.

For PU objects, this attribute is required; there is no default. The value can range from

1 through 255 for SNAX/XF and 2000 for SNAX/APN, if the limit for MAXLUS on the

corresponding line is not exceeded. Before the MAXLUS attribute can be altered for a

PU, all LUs for the given PU must be deleted using the DELETE command. Altering

the value for MAXLUS does not automatically alter the value for MAXPTS.

Note: For SNAX/APN, the value specified for MAXLUS on the LINE object also

includes the value of MAXLOCALLUS; the sum of MAXLOCALLUS and MAXLUS on

all PUs for the given line cannot exceed MAXLUS for the line.

MAXPTS - for SNAX/XF Only

MAXPTS specifies the maximum number of concurrent passthrough sessions that can

be active on LUs subordinate to this PU. This attribute applies only to PUs on

secondary lines.

Default: 0

Value: 1 - 1024

Objects: LINE

Default: 32 for LINE objects

Value: 1 - 2048 for LINE objects;

1 - 255 for PU objects (SNAX/XF)

1 - 2000 for PU objects (SNAX/APN)

Objects: LINE, PU

Default: MAXLUS value for this PU

Value: 0 - MAXLUS value for this PU

Objects: PU