SNAX/XF and SNAX/APN Configuration and Management Manual

Attributes for SNAX/XF and SNAX/APN
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
14-40
PASSTHRU - for SNAX/XF Only
names and addresses are assigned sequentially ascending numbers based on the root
name and address supplied in the ADD LU command. For example, if the root name
and address are (#XYZ008, 97), the next names and addresses would be (#XYZ009,
98), (#XYZ010, 99), (#XYZ011, 100), and so on. There is no relationship between an
LU’s name and its address.
If any error is encountered when using the ADD LU command, no LUs are added; all
LUs already added using the command are deleted. If a generated LU address
exceeds 255 (for PU type 2) or 63 (for PU type 1), an error occurs.
For more information about using NUMBEROFLUS, see the ADD LU command in
Section 13, SCF Commands for SNAX/XF and SNAX/APN in this manual.
PASSTHRU - for SNAX/XF Only
PASSTHRU specifies whether or not the LU can be used for passthrough sessions
between NonStop systems and an IBM host. This attribute is only applicable to LUs
associated with secondary lines.
PASSTHRU ON indicates that applications can use the specified LU for passthrough
sessions. PASSTHRU OFF prohibits passthrough sessions. If PASSTHRU ON is
specified, specify an appropriate value for the PU attribute MAXPTS. If you do not
specify a value, MAXPTS is set to a value equal to the value for MAXLUS.
PASSWORD
Depending on the value of the APPLTYPE attribute, PASSWORD specifies one of the
following for an APPL object:

A password that a Communications Network Management (CNM) application must
use when it issues a CONNECT request to the CNM or the Configuration Services
(CS) component of the service manager

A password that must be specified when starting the SNAX Creator application

A password that must be specified when adding a SNAX Creator-2 SU object

A password that a user or a connection management application must use in the
APPLNAME command to the SNAX/CM
Default: OFF
Value: ON | OFF
Objects: LU
Default: None
Value: String of 1 through 8 characters enclosed in double quotation marks (")
or single quotation marks (')
Objects: APPL