SNAX/XF and SNAX/APN Configuration and Management Manual

Attributes for SNAX/XF and SNAX/APN
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
14-48
PUNAME (Local LU Objects) - for SNAX/APN

The ALTER command cannot be used to change the PU name.

The PU must already be defined.
The PU name can be specified in uppercase or lowercase. SNAX/XF converts all
lowercase letters to uppercase.
PUNAME (Local LU Objects) - for SNAX/APN
When applied to the TLOGMGR LU or to a local LU used for APPC, PUNAME
specifies the name of the local PU, which must be #ZNT21.
The ALTER command cannot be used to change the PU name.
The PU name can be specified in uppercase or lowercase. SNAX/APN converts all
lowercase letters to uppercase.
PUNAME (Remote LU Objects) - for SNAX/APN
When applied to the ILOGMGR LU, to an acquired remote LU, or to a remote LU used
for APPC, PUNAME specifies the name of the remote PU to which this remote LU is
subordinate. The remote PU must already be defined through SCF before you add a
remote LU and specify its PUNAME attribute.
PUNAME is a required attribute for remote LUs. The ALTER command cannot be used
to change the PU name.
The PU name can be specified in uppercase or lowercase. SNAX/APN converts all
lowercase letters to uppercase.
QUEUE - for SNAX/APN Only
QUEUE specifies what occurs during a BIND request for this LU when the intended
session partner is at its session limit or is unable to comply with the PLU/SLU
specification in the BIND request. This attribute allows the queuing of BIND requests. It
applies only to acquired remote LUs, and is used only when PROTOCOL is CRT
(when LU subtype 1, 2, or 3 is specified) or ITI (when LU subtype 2 is specified).
Default: #ZNT21
Value: #ZNT21
Objects: LU
Default: None
Value: Name of controlling remote PU
Objects: LU
Default: OFF
Value: ON | OFF
Objects: LU