SNAX/XF and SNAX/APN Configuration and Management Manual

Attributes for SNAX/XF and SNAX/APN
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
14-54
RNRTIMER
Disconnect Mode (DM) command to any received frame that is not a mode-setting
command. The local station enters a Logical Disconnected State (LDS).
RNRTIMER
RNRTIMER specifies a value (in units of 1 second) for the RNR timer. This attribute
applies only to line type 58,5 (SDLC).
The RNRTIMER value is applied to a station either when a station receives RNR
(remote RNR state) or when a station is about to send RNR (local RNR state). This
timer is activated only when the RNRRECEIVE or RNRSEND attribute has also been
specified.
RSPTYPE - for SNAX/APN Only
RSPTYPE specifies the response type to be used for data associated with WRITE
requests. This attribute is ignored when the PROTOCOL attribute for the LU is not
specified, is set to SNALUXS, or is set to NAM.
If PROTOCOL is LOGON, RSPTYPE specifies the response type to be used for
requests sent to the remote LUs created by the TLOGMGR. If PROTOCOL is CRT or
ITI, RSPTYPE specifies the response type to be used for WRITE requests sent by this
remote LU. If PROTOCOL is NAM, exception response is always used and the
RSPTYPE attribute is ignored.
The following values are valid for this attribute:
Default: 0
Value: 0 - 255 seconds (maximum value is 4 minutes and 15 seconds)
Objects: LINE
Default: DR
Value: DR | ER
Objects: LU
DR signifies definite response (DR) mode. A response, whether positive or
negative, is sent to every request.
ER signifies exception response (ER) mode. A response is sent only if an error
was encountered in the processing of the request.