SNAX/XF and SNAX/APN Configuration and Management Manual

Attributes for SNAX/XF and SNAX/APN
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
14-56
SCREENSIZE (TLOGMGR LU Only)
If more than one SAP is defined, each SAP’s definition is separated by a semicolon (;).
SCREENSIZE (TLOGMGR LU Only)
SCREENSIZE specifies whether the Default or Alternate Screensize field of the CINIT
will be used in the BIND sent to the terminal during XLF logon processing.
DEFAULT specifies that the Default Screensize field of the CINIT will be used in the
BIND.
ALTERNATE specifies that the Alternate Screensize field of the CINIT (if present) will
be used in the BIND. If SCREENSIZE ALTERNATE is specified and the Alternate
Screensize field is not present in the CINIT, the Default Screensize field of the CINIT
will be used in the BIND.
SENDUNBIND01 - for SNAX/APN Only
SENDUNBIND01 specifies the type of UNBIND request that is sent when a CLOSE
request is received from the application on an LU of protocol type CRT. If the
SENDUNBIND01 attribute is set to YES, an UNBIND of type 01 is sent, otherwise, an
UNBIND of type 0F is sent.
SERVICECOUNT
SERVICECOUNT specifies the number of times that this PU is serviced before
proceeding to the next PU in the PU service list.
The PU service list controls the number of SDLC I-frames queued for transmission that
are sent by a PU. When the PU service list determines that it is time for this PU to send
queued transmissions, a number of I-frames up to the SERVICECOUNT value are
transmitted to this PU before the next PU on the PU service list is serviced. The
following considerations apply to this attribute:

SERVICECOUNT applies only to PUs subordinate to a primary line. It has no
meaning for PUs subordinate to a secondary line.
Default: DEFAULT
Value: DEFAULT | ALTERNATE
Objects: TLOGMGR LU only
Default: NO
Value: YES | NO
Objects: LU
Default: 1
Value: 1 - 65535
Objects: PU