APN Configuration and Management Manual

Attributes for SNAX/XF and SNAX/APN

SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006

14-74

TYPE (Remote LU Objects) - for SNAX/APN

When applied to remote LU objects, TYPE specifies the device type (always 14) and

subtype for a remote LU. For SNAX/APN, the subtype values include:

All of these integer values are specified following the number 14 and a command,

surrounded by parentheses, such as in the value specified TYPE (14,0). The number

14 indicates the device type for an LU. This attribute is required; there is no default.

The subtype is also required.

TYPE (PU Objects)

When applied to a PU, TYPE specifies the device type (always 13) and subtype for the

PU. For SNAX/APN, the subtype must always be specified as 21. This attribute must

be specified. The following values indicate the particular subtypes:

Default: None

Value: ( 14, { 0 | 1 | 2 | 3 | 4 | 21 } )

Objects: LU

0 provides a generalized, user-definable process-to-process communications

capability for applications.

1 defines the formats and protocols for SNA support of a Remote Job Entry (RJE)

workstation operating in a batch environment.

2 defines the session rules for communicating in an interactive display

environment with devices attached to a 3270 cluster controller or a T6600

controller.

3 defines the session rules for communicating with printer devices attached to a

3270 cluster controller.

4 defines the session rules for communicating with data-processing and word-

processing media support devices attached to a cluster controller.

21 is an internal HP value that applies only when the PROTOCOL attribute is

LOGON or SNALUXS.

Default: None

Value: (13, integer), where integer is { 1 | 2 | 21 }

Objects: PU

1 specifies that the device subtype corresponds to an IBM PU type 1.

2 specifies that the device subtype corresponds to an IBM PU type 2.

21 specifies that the device subtype corresponds to an IBM PU type 2.1.