SNAX/XF and SNAX/APN Configuration and Management Manual

Attributes for SNAX/XF and SNAX/APN
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
14-76
X21NRDY
X21NRDY
This attribute only applies to unsupported X.21 switched lines. The attribute description
is given because the attribute appears in SCF INFO LINE, DETAIL displays.
X21NRDY specifies the type of DTE not ready signal the X.21 DTE sends when
entering the quiescent state. ON indicates that the X.21 DTE sends a “DTE NOT
READY—CONTROLLED” signal. OFF indicates that it sends a “DTE NOT READY—
UNCONTROLLED” signal. This attribute applies only to SDLC lines.
X21T1TIMEOUT
This attribute only applies to unsupported X.21 switched lines. The attribute description
is given because the attribute appears in SCF INFO LINE, DETAIL displays.
X21T1TIMEOUT specifies the T1 time limit that the X.21 DTE uses when waiting for a
DCE response during call establishment. T1 represents the T1 timer. This attribute
applies only to SDLC lines.
The valid range of values for this attribute is 0 through 10 minutes, 5 seconds, and 35
hundredths of a second (0 through 10:5.35). If the value specified is 0, ADCCP does
not use the specific T1 timer during the X.21 call establishment process.
X21T2TIMEOUT
This attribute only applies to unsupported X.21 switched lines. The attribute description
is given because the attribute appears in SCF INFO LINE, DETAIL displays.
X21T2TIMEOUT specifies the T2 time limit that the X.21 DTE uses when waiting for a
DCE response during call establishment. T2 represents the T2 timer. This attribute
applies only to SDLC lines.
The valid range of values for this attribute is 0 through 10 minutes, 5 seconds, and 35
hundredths of a second (0 through 10:5.35). If the value specified is 0, ADCCP does
not use the specific T2 timer during the X.21 call establishment process.
Default: OFF
Value: ON | OFF
Objects: LINE
Default: 3 seconds
Value: 0 - 10:55.35
Objects: LINE
Default: 20 seconds
Value: 0 - 10:55.35
Objects: LINE