SNAX/XF and SNAX/APN Configuration and Management Manual

PTrace Reference for SNAX/XF and SNAX/APN
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
15-42
040: MS^REPLY^TRACE
P1-P6: nnnnnn nnnnnn nnnnnn nnnnnn nnnnnn nnnnnn
gives the values of the control fields in the message-system control block
(MSGCB). These fields are for HP internal use.
REQ SIZE: #nnnn
gives the length, in bytes, of the data received in the incoming request.
MAX REPLY SIZE: #nnnn
gives the maximum length, in bytes, allowed for outgoing reply data.
0100 1214 ...
if present, is the data in the incoming request. This data is for HP internal use.
040: MS^REPLY^TRACE
This trace record contains a reply sent by SNAX level 2 to the X25AM I/O process, in
response to an incoming request recorded by trace-record type 39. It applies only to
X.25 lines.
L2
indicates that this is a request reported by SNAX level 2.
MSCB REPLY
indicates that level 2 sent a reply message through its internal message interface.
FEOK
is the literal associated with the file-system error number returned, in this case, for
the incoming request. FEOK indicates that no errors or warnings occurred.
INCOMING REQUEST
introduces information about the incoming request being replied to.
X25 -> TS
identifies the source and destination of the incoming request being replied to. For
this trace-record type, the source is always X25 (X25AM) and the destination is
always TS (the line handler).
Record Type : 040 MS^REPLY^TRACE
L2 MSCB REPLY FEOK
INCOMING REQUEST X25 -> TS X25TS^RECDATA
REQID: 000220 000221 P1-P6: 140461 000026 000001 000002 000030
000000
OUTGOING REPLY REPLY DATA SIZE #0000
REQID: 000220 000221 P1-P6: 000000 000026 000001 000002 000030
000000