APN Configuration and Management Manual

PTrace Reference for SNAX/XF and SNAX/APN

SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006

15-44

041: MS^SEND^DATA^TRACE

This trace record contains outgoing data sent by SNAX level 2 to the X25AM I/O

process. It applies only to X.25 lines.

indicates that this is a request reported by SNAX level 2.

MSPROCS

is an identifier for HP internal use.

SEND DATA

indicates that this trace record contains a request to send data.

TS -> X25

identifies the source and destination of the message-system request. For this

trace-record type, the source is always TS (the line handler), and the destination is

always X25 (X25AM).

TSX25^SENDDATA

identifies the type of request, which is one of the following:

If TSX25^SENDDATA is displayed, additional communication between the

processes is done using the first word of the buffer, and the next field further

identifies the communication, as described below.

Record Type : 041 MS^SEND^DATA^TRACE

L2 MSPROCS SEND DATA TS -> X25 TSX25^SENDDATA - Data

REQID: 000015 127512 P1-P6: 140460 000026 000001 000002 000024

000001

WRITE COUNT: #0020 READ COUNT: #0000

ASCII EBCDIC

0000 2D00 0000 0002 6B80 0011 0101 0500 ! - k ! ,

0000 0000 ! !

TSX25^ALLOW^CALLIN Allow call-in

TSX25^ATTACH Attach

TSX25^CALLACCEPT Call accept

TSX25^CALLCLEAR Call clear

TSX25^CALLOUT Call out

TSX25^DETACH Detach

TSX25^SENDDATA Send data