SNAX/XF and SNAX/APN Configuration and Management Manual

PTrace Reference for SNAX/XF and SNAX/APN
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
15-46
042: MS^SEND^DATA^COMPLETION^TRACE
MSCB LDONE
indicates that the message-system LDONE function was invoked through the
internal message interface to SNAX level 2.
ORIGINAL REQUEST
introduces information about the original request being replied to.
TS -> X25
identifies the source and destination of the original request being replied to. For
this trace-record type, the source is always TS (the line handler), and the
destination is always X25 (X25AM).
X25TS^SENDDATA
identifies the type of request being replied to, which is one of the following:
REQID: nnnnnn nnnnnn
is the number used by the line handler to identify the request being replied to.
This number matches the REQID displayed in the type 41 trace record for the
corresponding request.
P1-P6: nnnnnn nnnnnn nnnnnn nnnnnn nnnnnn nnnnnn
gives the values of the control fields in the message-system control block
(MSGCB) for the request being replied to. These fields are for HP internal use.
RESPONSE RECEIVED:
introduces information about the reply.
FEOK
is the literal associated with the file-system error number returned, in this case, on
the reply. FEOK indicates that no errors or warnings occurred.
TSX25^ALLOW^CALLIN Allow call-in
TSX25^ATTACH Attach
TSX25^CALLACCEPT Call accept
TSX25^CALLCLEAR Call clear
TSX25^CALLOUT Call out
TSX25^DETACH Detach
TSX25^SENDDATA Send data