APN Configuration and Management Manual

PTrace Reference for SNAX/XF and SNAX/APN

SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006

15-61

173: TS^TO^CONMGR

This trace record contains a message sent by the line handler to the Concentrator

Manager process. This trace record applies only to line type 58,5.

LINK

indicates that the message-system LINK function was invoked.

TS -> CONMGR

identifies the source and destination of the message-system request. For this

trace-record type, the source is always TS (the line handler), and the destination is

always CONMGR (the concentrator manager).

Activate Path

identifies the type of service being requested by the line handler: in this case, a

request to activate the controller.

MSGCB: %nnnnnn.nnnnnn

gives the address of the message-system control block (MSGCB) within SNAX.

This address matches the MSGCB address displayed in the LDONE trace record

for the completion of this LINK request.

248: CLB^IN^TRACE^ID

This trace record contains data received by the CIU-to-LIU bus (CLB) from the

communications line interface processor (CLIP) for the SNAX line being traced.

It applies only to line type 58,5.

04/15/96 22:57:07.542029 >000.000000 #19

Record Type : 173 TS^TO^CONMGR

LINK TS -> CONMGR IOP_CONMGR_ACTIVATE_PATH

MSGCB: %000016.071734

LINKER: #00,#0282 LISTENER: #00,#0281

REQUEST CTRL :

0000 0022 0000 0041 0000 0000 0003 2453! " A $S!

5953 5445 4D2E 5357 414E 2E43 3933 3132!YSTEM.SWAN.C9312! ( +

5030 3000 0000 0000 0000 0000 0000 0000!P00 !&

0000 2020 0000 0000 0000 ! !

(Record Type : 248 CLB^IN^TRACE^ID

CLB In 01: ReceivedText Frame bytes: 24

0186 012C 4280 0400 0000 000C 0100 2D00 ! ,B - ! f

0000 0002 EB80 0011 ! !