APN Configuration and Management Manual

SNAX/XF and SNAX/APN BINDs

SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006

B-5

BIND Parameters

This subsection describes the BIND parameters mentioned in this appendix.

TYPE type-value

specifies the type of BIND command represented by this BIND image. Any

hexadecimal values between %H00 and %H0F can be specified for type-value;

however, only 0 and 1 are currently defined, where:



%H00 = a negotiable BIND.



%H01 = a non-negotiable BIND. (This is the default.)

FMPROF fm-profile-value

specifies the function management profile (byte 2 of the BIND image). Any

hexadecimal number in the range of %H00 to %HFF can be specified for fm-

profile-value.

The default value is %H03.

TSPROF ts-profile-value

specifies the transmission services profile (byte 3 of the BIND image). Any

hexadecimal number in the range of %H00 to %HFF can be specified for ts-

profile-value.

The default value is %H03.

PRIPROT priprot-value

specifies the primary LU protocol (byte 4 of the BIND image). Any hexadecimal

number in the range of %H00 to %HFF can be specified for priprot-value.

The default value is %HB1.

SECPROT secprot-value

specifies the secondary LU protocol (byte 5 of the BIND image). Any hexadecimal

number in the range of %H00 to %HFF can be specified for secprot-value.

The default value is %H90.

COMPROT comprot-value

specifies the common LU protocols (bytes 6 and 7 of the BIND image). Any

hexadecimal number in the range of %H0000 to %HFFFF can be specified for

comprot-value.

Note that the required value for 6530 devices is %H7080.

The default value is %H3080.