SNAX/XF and SNAX/APN Configuration and Management Manual

Error Messages
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
C-2
SNAX Error 00003

The object type in the SUB modifier specified a type of object that was not
configured. For example, you issued STATUS LINE $SNA1, SUB LU, but no LUs
subordinate to $SNA1 were configured.

The select state in the SEL modifier specified a select state that no object was
currently in. For example, you issued STATUS LINE $SNA1, SUB LU, SEL
STARTING, but none of the LUs subordinate to $SNA1 were in the STARTING
state.
Effect. The command fails.
Recovery. None.
SNAX Error 00003
Cause. The START LU command failed because of the failure of the SNA ACTLU
command.
Effect. The LU is not started.
Recovery. Retry the command.
SNAX Error 00004
Cause. During processing of a STOP LU command for an LU on a primary or
secondary line or an ABORT LU command for an LU on a secondary line, an SNA
DACTLU command ended in error.
Effect. The STOP or ABORT command fails.
Recovery. None. If the error persists, contact your support provider.
SNAX Error 00005
Cause. During processing of a STOP PU command for a PU on a primary or
secondary line or an ABORT PU command for a PU on a secondary line, an SNA
DACTPU command failed.
Effect. The STOP or ABORT command fails.
Recovery. None. If the error persists, contact your support provider.
SNAX E-00003 ACTLU Failed: object-name
SNAX E-00004 DACTLU Failed: object-name
SNAX E-00005 DACTPU Failed: object-name