APN Configuration and Management Manual

Error Messages

SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006

C-4

SNAX Error 00011

Cause. The maximum number of LUs has been used for a PU or LINE object.

Effect. The command fails.

Recovery. Delete unused LUs and retry the command, or reconfigure the LINE or PU

object with a larger value for the MAXLUS attribute.

SNAX Error 00012

Cause. Processing of the current command was terminated because one or more LUs

(either objects of the command or LUs subordinate to the command object) were not in

the STOPPED state. Commands that can receive this error are ALTER LU, DELETE

LU, and STOP PU.

Effect. The command fails.

Recovery. Stop the LUs and retry the command.

SNAX Error 00013

Cause. This command could not be processed because SNAX was still processing a

previous command for the same object.

Effect. The command fails.

Recovery. Retry the command later.

SNAX Error 00014

Cause. An ADD PU command failed because the maximum number of PUs on a LINE

object had already been added.

Effect. The PU is not added.

Recovery. Either delete an unused PU from that LINE object, or alter the LINE object

to increase the value of the MAXPUS attribute.

SNAX E-00011 Maximum number of LUs reached: object-name

SNAX E-00012 LU not stopped: object-name

SNAX E-00013 Previous request is not finished: object-name

SNAX E-00014 Maximum number of PUs reached: object-name