SNAX/XF and SNAX/APN Configuration and Management Manual
Error Messages
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
C-5
SNAX Error 00015SNAX Error 00015
SNAX Error 00015
Cause. A START LU command failed because the PU to which the LU was attached
was not in the STARTED state.
Effect. The LU is not started.
Recovery. Start the PU and retry the command.
SNAX Error 00016
Cause. The command could not be executed because a PU was not in the STOPPED
state. The PU can be either the command object (as in the case of an ALTER PU or
DELETE PU command) or a PU subordinate to the command object (as in the case of
a STOP LINE command).
If this error occurs during execution of a STOP LINE command, it indicates that at least
one PU subordinate to the specified line was not stopped.
Effect. The command fails. If the command was STOP LINE, at least one PU is not
stopped.
Recovery. Stop the PU and retry the command.
SNAX Error 00017
Cause. An attempt was made to stop or abort a PU that was already in the STOPPED
state.
Effect. The STOP or ABORT command fails.
Recovery. No action is necessary.
SNAX Error 00018
Cause. A STOP or ABORT command failed because of an error encountered in the
response to a REQDISCONTACT command.
Effect. The STOP or ABORT command fails.
Recovery. None.
SNAX E-00015 PU not started: object-name
SNAX E-00016 PU not stopped: object-name
SNAX E-00017 PU is stopped: object-name
SNAX E-00018 REQDISCONTACT failed: object-name