APN Configuration and Management Manual

Error Messages

SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006

C-8

SNAX Error 00028

Cause. The referenced line has been configured with PROFILE, but it has not been

added with SCF.

Effect. The command fails.

Recovery. Add the line and retry the command. When using multiple service

managers, issue the INFO LINE command to determine the name of the service

manager to which the line was added.

SNAX Error 00029

Cause. The command could not be executed because the service-manager process

was not in the STARTED state.

Effect. The command fails.

Recovery. Start the service manager and retry the command.

SNAX Error 00030

Cause. An SNA ADDLINK request failed on an ADD LINE command.

Effect. The line is not added.

Recovery. Retry the ADD LINE command. If the error persists, trace the line and the

service manager. Contact your support provider, providing the results of the trace.

SNAX Error 00031

Cause. An internal error occurred in the line-handler process.

Effect. The command fails.

Recovery. Retry the command. If the problem persists, trace the line and the service

manager. Contact your support provider, providing the results of the trace.

SNAX E-00028 \system-name.line-name not added to Service

Manager \system-name.$service-manager-name

SNAX E-00029 \system-name.$service-manager-name not started.

SNAX E-00030 ADDLINK received error: object-name.

SNAX E-00031 Internal Error: Unknown Snats response from

object-name