SNAX/XF and SNAX/APN Configuration and Management Manual

Error Messages
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
C-9
SNAX Error 00032SNAX Error 00032
SNAX Error 00032
Cause. An ALTER SUBSYS command failed because the specified service manager
was in the STARTED state. You can alter the SSCPID and XPAGES attributes only
when the service manager is in the STOPPED state.
Effect. The ALTER SUBSYS command fails.
Recovery. None.
SNAX Error 00033
Cause. An LU Network Services (LUNS) SET table was not allocated because one of
the following situations occurred:

The SETTAB attribute in the SCF ALTER SUBSYS command named a file that did
not exist.

The SCF DEVICE SETTABNAME configuration modifier named a file that did not
exist.
Effect. No SET table is allocated, even though (if the second situation occurred) a
subsequent START SUBSYS command succeeds.
Recovery. Make sure that the file named in the SETTAB attribute or the
SETTABNAME configuration modifier is an existing SET table and that the LUNS ESS
and SET tables are valid tables. If no problems are apparent, contact your support
provider.
SNAX Error 00036
Cause. The path already being used was specified as the destination in a SWITCH
command.
Effect. No change occurs.
Recovery. Make sure that the path you specified is the one you want. If it is not,
specify the correct path.
SNAX E-00032 \system-name.$service-manager-name is started.
SNAX E-00033 LUNS Error: \system-name.$SSCP
SNAX E-00036 PATH is already primary for object-name