APN Configuration and Management Manual

Error Messages

SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006

C-10

SNAX Error 00039

Cause. A PRIMARY command was issued to change the primary processor for the

service manager while an application was active. When an application is active, the

primary and backup CPUs for the service manager cannot be switched.

Effect. The PRIMARY command fails.

Recovery. Stop the application and reissue the command.

SNAX Error 00040

Cause. An invalid CPU number was specified in a PRIMARY command. The current

backup CPU must be specified as the new primary CPU.

Effect. The PRIMARY command fails.

Recovery. Retry the command using the CPU number of the current backup CPU.

SNAX Error 00041

Cause. An ALLOWOPENS or STOPOPENS command was issued for a switched

floating LU not currently connected to a line. A switched floating LU must be connected

to a line before its open state can be changed.

Effect. The command fails.

Recovery. Wait until the LU is temporarily subordinated to a line before issuing the

command. Note that a switched floating LU becomes temporarily subordinated to a line

only when a dial-in call is received; there is no way to subordinate a switched floating

LU to a line directly.

SNAX Error 00042

Cause. Both the PROGRAM and the PROG9370 attributes were specified in an ADD

LINE or ALTER LINE command. These two attributes are mutually exclusive.

Effect. The command fails.

Recovery. Retry the command, specifying only one of the two attributes.

SNAX E-00039 Application is active: object-name

SNAX E-00040 Invalid Cpu Number for object-name

SNAX E-00041 Floating Lu not connected: object-name

SNAX E-00042 Both PROG and PROG9370 were specified as

line attributes.