APN Configuration and Management Manual

Error Messages

SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006

C-12

SNAX Error 00045

Cause. Another operation is currently taking place on the object of this command or

on one of its superior objects, and that operation is mutually exclusive with this

command.

Effect. The command fails.

Recovery. Retry the command.

SNAX Error 00046

Cause. The number of extended memory pages specified through the XPAGES

attribute was too small. There are two possible conditions:



The values of MAXLUS, MAXPUS, and XPAGES for the LINE object are all directly

related. If MAXLUS and MAXPUS are small, then the number of XPAGES needed

is small. If the number of MAXLUS and MAXPUS is large, then the number of

XPAGES must be large.



The XPAGES value is too small for even basic operation.

Effect. The command fails.

Recovery. Lower the value of MAXLUS or MAXPUS, or raise the value of XPAGES

for the LINE object type. Alternatively, specify zero (0) for XPAGES to allow SNAX to

calculate the XPAGES value automatically.

SNAX Error 00047

Cause. The number of extended memory pages specified through the XPAGES

attribute exceeds the maximum value allowed.

Effect. The command fails.

Recovery. Lower the value of XPAGES.

SNAX E-00045 A mutually exclusive operation is taking place.

SNAX E-00046 Too few XPAGES: Raise XPAGES value, or lower

MAXLUS/MAXPUS values.

SNAX E-00047 Value of XPAGES is too large: Lower XPAGES

value.