SNAX/XF and SNAX/APN Configuration and Management Manual

Error Messages
SNAX/XF and SNAX/APN Configuration and Management Manual—425836-006
C-13
SNAX Error 00048SNAX Error 00048
SNAX Error 00048
Cause. A conflict exists between the values specified for the IOPAGES attribute and
the RECSIZE attribute for a line. The values of IOPAGES and RECSIZE are directly
related. If the RECSIZE value is small, then the number of IOPAGES needed is small.
If the RECSIZE value is large, then the number of IOPAGES needed is large.
Effect. The command fails.
Recovery. Lower the value of RECSIZE or raise the value of IOPAGES.
SNAX Error 00049
Cause. The value specified for the IOPAGES attribute exceeds the maximum value
allowed.
Effect. The command fails.
Recovery. Lower the value of IOPAGES.
SNAX Error 00050
Cause. A STOP SESSION command was issued for an LU that had no current LU-LU
session.
Effect. No change occurs.
Recovery. No action is necessary.
SNAX Error 00052
Cause. An attempt was made to start a trace in a backup process that did not exist.
Effect. The backup trace is not started.
Recovery. Restart the backup process, then retry the TRACE command.
SNAX E-00048 Too few IOPAGES: Raise IOPAGES value,
or lower RECSIZE value.
SNAX E-00049 Value of IOPAGES is too large: Lower IOPAGES
value.
SNAX E-00050 No LU-LU session active.
SNAX E-00052 BACKUP process does not exist.